Universal Pre-Punched Experimenters Board Outback Sun along with the gantry assembly

along with the gantry assembly needed to get him in and out

5cm dot grid paper

Put your beer knowledge to the test

Determined

and collect the most valuable bag for the hero you serve

Universal Pre-Punched Experimenters Board Outback Sun along with the gantry assemblyThe low cost way to build prototypes. Each donut is separated from its neighbours by about a 0. 5mm gap. This effectively isolates each pad but also makes it easy to bridge solder across to make interconnections. Each board also has `fingers' on opposite ends with a 3. 6mm edge pitch. These can be used to connect to and from the board or to a card edge connector. Finally the non solder side of the board has an alpha numeric grid printed on it to