CRL Brushed Stainless UV Glass-to-Glass Cone Hinge - 15/16" (24 mm) Cone Tripple-Ripple Plated Diamond Drill Bits 90° Manual Tilt

90° Manual Tilt

Available in six standard sizes in grits from 36X (Super Coarse) to CORK (Polishing) to fit most any upright belt sanding machine

apply slight pressure on center of follower plate while pumping dispenser to eliminate trapped air

64 m) long

220X - Extra Smooth: Fine Frosted Finish (Glass Shelf Edge)

CRL Brushed Stainless UV Glass-to-Glass Cone Hinge - 15/16" (24 mm) Cone Tripple-Ripple Plated Diamond Drill Bits 90° Manual TiltFor Inset or Overlay Doors Available in Two Sizes CRL's UV Cone Glass to Glass Cone Hinges are designed for all glass showcases with inset or overlay doors. The doors must overlap the end of the glass side panels by 1" to 2" (25 to 50 mm) depending on which Hinge is being used. The Hinges are bonded on exterior end panels and the overlap portion of the glass door. The Hinges open to a maximum of 180 degrees. Fabricated in brushed stainless steel.