12V 30A 1 Channel Relay Module With Optocoupler Isolation High Power Raspberry Pi 3 Official Case for Model B and B+(White & Pink) Install your FPV camera on

Install your FPV camera on the front-facing camera mount with appropriate tilt angle for racing (typically 15-30 degrees)

reducing ground setup time from 15-20 minutes to under 2 minutes

reducing cloud bandwidth requirements

you can cut the strip at designated cut points (usually every 3 LEDs)

downlight connections

12V 30A 1 Channel Relay Module With Optocoupler Isolation High Power Raspberry Pi 3 Official Case for Model B and B+(White & Pink) Install your FPV camera on12V 30A 1 Channel Relay Module With Optocoupler Isolation High Power 12V 30A 1 Channel Relay Module With Optocoupler Isolation High Power This 1 channel 12V 30A relay control board module with optocoupler modules is compliant with international safety standards, control and load areas isolation trenches it has a single relay a genuine. The inputs of 1 Channel 12V 30A Relay Module are isolated to protect any delicate control circuitry. It can be used